9
Drive5 Submenu of the System Menu
The Drive5 submenu allows you to configure eSATA or third SATA devices.
Figure 5. Drive5 Submenu
Exiting from System Menu
When you have finished setting the parameters on this menu, you can either exit from the setup utility, or move to
another menu. If you wish to exit from the setup utility, press the [Esc] key or use cursor keys to go to the Exit menu. If
you wish to move to another menu, use cursor keys.
Table 5: Fields, Options and Defaults for the Drive5 Submenu of the System Menu
Menu Field Options Default Description
Drive5:
■
Disabled
■
Enabled
[Enabled] Enables or disables Drive5, if available. (Drive5 is attached via an
optional port replicator).
Type:
---
--- Displays the drive device type in Drive5. This field is for information
only.
Model:
---
--- Displays the model number of the device in Drive5. This field is for
information only, and is only present when a Drive5 is available.
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Item Specific Help
[Disabled]
The drive is disabled.
[Enabled]
The drive is enabled.
Drive5 [None]
Drive5: [Enabled]
Type: None
▲
Phoenix SecureCore(tm) Setup Utility
Info System Advanced Security Boot Exit
System Menu
To Next Page
Loading...
