Port Replicator
15
Attaching a Port Replicator
The Port Replicator can be attached on your
notebook while the power is on, while in
suspend mode, while in Hibernation, or
while the power is off. To attach the Port
Replicator, follow these steps:
1. Align the Port Replicator connector on
the lower surface of your notebook with
the connector on top of the Port
Replicator.
2. Push your notebook down to connect it
to the Port Replicator securely.
Figure 2. Attaching the Port Replicator
Detaching a Port Replicator
The Port Replicator can be detached from your
notebook while the power is on, while in suspend
mode, or while the power is off.
To detach the system from the Port Replicator,
pull the lift lever located at the end of the port
replicator away from the base until the system
rises slightly. Lift and detach your notebook.
Figure 3. Detaching the Port Replicator
Figure 4. Using the Lifts
Lift Lever
To Next Page
Loading...
