vi
For safety, users should ensure that the
electrical ground of the power utility, the
telephone lines and the metallic water
pipes are connected together. Users
should NOT attempt to make such
connections themselves but should
contact the appropriate electric
inspection authority or electrician. This
may be particularly important in rural
areas.
+
The Load Number assigned to each telephone
terminal device denotes the percentage of the
total load to be connected to a telephone loop or
circuit which is used by the device to prevent
overloading. The termination on a loop may
consist of any combination of devices such that
the total of the load numbers of all devices does
not exceed 100.
UL Notice
This unit requires an AC adapter to operate. Use
only UL Listed Class 2 adapter, output rating
16VDC, 3.75A. Refer to the illustration below for
the correct AC Adapter output polarity:
For Authorized Repair Technicians Only
To reduce the risk of fire, use only #26
AWG or larger telecommunications line
cord.
For continued protection against risk of
fire, replace only with the same type and
rating fuse.
Danger of explosion if Lithium (CMOS)
battery is incorrectly replaced. Replace
only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufac-turer’s instruction.
Proper Disposal of Battery
Under federal, state or local law, it may be illegal
to dispose of batteries by putting them in the
rubbish bin or trash cans. Please take care of
our environment and dispose of batteries
properly. Check with your local government
authority for details regarding recycling or
disposing of unwanted batteries.
To Next Page
Loading...
