81
Headphone Jack
The headphone jack allows you to connect headphones or powered external speakers to your notebook.
Your headphones or speakers must be equipped with a 1/8” (3.5 mm) stereo mini-plug. In order to connect
headphones or speakers follow these easy steps:
1 Align the connector with the port opening.
2 Push the connector into the port until it is seated.
Universal Serial Bus Ports
The Universal Serial Bus 2.0 ports (USB) allow
you to connect USB devices such as external
game pads, pointing devices, keyboards and/or
speakers. There are three USB 2.0 ports on your
notebook: two on the left side and one on the
right.
To connect a USB device follow these steps:
1 Align the connector with the port opening.
2 Push the connector into the port until it is seated.
Figure 27. Connecting a USB Device
MICROSOFT WINDOWS VISTA USERS ONLY: WHEN ATTACHING A USB DEVICE, DO ONE OF THE FOLLOWING: BE
SURE TO ATTACH THE DEVICE BEFORE TURNING ON YOUR SYSTEM, OR, WAIT FOR APPROXIMATELY THREE
MINUTES AFTER THE SYSTEM BOOTS UP BEFORE ATTACHING THE USB DEVICE.
IF YOU PREFER NOT TO WAIT TO CONNECT YOUR USB DEVICE, YOU MUST DISABLE THE SELECTIVE SUSPEND
FEATURE. TO DO SO, GO TO START > CONTROL PANEL. IN THE LEFT PANEL, SELECT CLASSIC VIEW. CLICK ON
POWER OPTIONS > CHANGE PLAN SETTINGS > CHANGE ADVANCED POWER SETTINGS. SELECT USB SETTINGS,
THEN SELECT DISABLED FROM THE PULL-DOWN MENU FOR USB SELECTIVE SUSPEND SETTING. CLICK [OK] TO
COMPLETE THE PROCESS.
IF YOU PLUG HEADPHONES INTO THE HEADPHONE JACK, THE BUILT-IN SPEAKERS WILL BE DISABLED.
To Next Page
Loading...
