Working w ith the notebook
Connecting the mains adapter to the Port Replicator
1
2
3
► Connect the m ains adap ter cable to the DC
jack (DC IN) of the Po rt Replicator (1).
► Connect the power cable to the
mains a d apter (2).
► Plug the power cable into the mains
socket (3).
When the notebook is connected to a Port Replicator, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This pro file will b e loaded, as
soon as the notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the O N/O F F
switch on the port
replicator to sw
itch the notebook on.
The power-on indicator of the Port
Replicator lights up .
Switching
off notebook via Port Replicator
► Close all applications and shut down y our operating system (please refer
to the manual f or the operating system).
If the notebook cannot be shut do wn prop erly, press th e ON /OF F button
on the Port Replicator for approx. four seconds. The notebook w ill switch
off. Any u nsa ved data may however be lost.
50 Fujitsu Technology Solutions
To Next Page
Loading...
