Removing and installing components
during servicing
Preparing to remove components
If you are going to remove or ch ange system components, prepare for the remo val as follows:
Please observe the safety information in chapter "Important notes", Page 6.
Remove the power plug from the mains outlet !
► Switch the device off.
The de vice must not be in energy-saving mode !
► Close the LCD screen.
► Remove all the cables from the device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent the device from being scratch ed.
► Remove the battery (see "
Removing a battery", Page 28).
70 Fujitsu Technology Solutions
To Next Page
Loading...
