Fujitsu Lifebook S760 - Error Messages on the Screen

Troublesho oting and tips
Error messages on the screen
Errormess agesonthe screenErrormessage:
This section describes the error messages generated by the B IO S Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or our customer service centre.
Error message/cause Resolution
CMOS battery bad
If the error message occurs repe
atedly, the
buffer battery in the notebook i
s flat.
► Contact your sales outlet or our customer
service centre.
System CMOS checksum bad - defau
lt configuration
used
The system configuration info
rmation is
incorrect.
► Switch the notebook off.
► Switch the notebook on.
► Press the function key
F2
to acces s the
BIOS Setup.
► In the BIO Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed a t offset: xxxx Failing Bits:
zzzz zzzz
When te sting the extended memory an error has
resulted at the a ddress xxxx.
► Check whether the additional memory
module has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
► Start the BIOS Setup (Primary Master
submenu) and select the correct settings.
Keyboard controller error
► Switch the notebook off with the ON/OF F
switch.
► Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you are using an external ke
yboard:
► Check the connection an d reboo
tthe
notebook.
nn Stuck key
► Make sure that no key is presse
d.
Operating system not found
► Check in the BIOS Setup whether your hard
disk has been set co rrectly.
► Make sure that the operating system is
installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This error message appe ars if an error occurs
during the s elf-test be fore starting the operating
system.
► Press the
F1
function key to start the
operating system.
► Press the function key
F2
to acces s the
BIOS Setup.
Fujitsu Technology Solutions 85