Fujitsu Lifebook S760 - Page 24

24
LifeBook S Series BIOS
Figure 16. Security Menu
Table 16: Fields, Options and Defaults for the Security Menu
Menu Field Options Default Description
Supervisor
Password is:
–— Clear A display-only field. Set is displayed when the system supervisor password is set
and Clear when it is not.
User Password is: –— Clear A display-only field. Set is displayed when the general user
password is set, and Clear when it is not.
Set Supervisor
Password
–— [Enter] Sets, changes or cancels the Supervisor Password. The Supervisor Password may
be up to 32 characters long and must include only letters or numbers (no sym-
bols). Passwords are NOT case-sensitive. To cancel a password press the Enter
key instead of entering characters in the Enter New Password field and in the
Re-enter New Password field. When a Supervisor Password is set it must be
used to access the BIOS setup utility.
Set User Password –— [Enter] This field can only be accessed if the Supervisor Password is set. Sets, changes or
cancels the User Password. A User Password may be up to 32 characters long
and must include only letters or numbers (no symbols). Passwords are NOT
case-sensitive. To cancel a password press [Enter] key instead of entering char-
acters in the Enter New Password field and in the Re-enter New Password field.
When a User Password is set it must be used to access the BIOS setup utility.
Minimum User
Password Length:
–— [0] Supervisor can set password length (0 to 32) for user password. User cannot set
a password shorter than the minimum length.
Password on Boot:
■
Disabled
■
First Boot
■
Every Boot
[Disabled] When set to First Boot, a password (User or Supervisor) is required just once
after the Power On Self Test (POST) before the operating system will be read
from a disk. When set to Every Boot, a password (User or Supervisor) is required
every time after the Power On Self Test (POST) before the operating system will
be read from a disk. When set to Disabled no password is required.
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
▲
Item Specific Help
Press <Enter> key to
set Supervisor Password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
Supervisor Password Is: Clear
User Password Is: Clear
Set Supervisor Password [Enter]
Set User Password [Enter]
Minimum User Password Length: [0]
Password on Boot: [Disabled]
On Automatic Wake up: [Disabled]
KB Lock on Resume: [Disabled]
Boot from Removable Media: [All]
Flash Write: [Enabled]
Hard Disk Security
Owner Information
TPM (Security Chip) Setting
▲▲ ▲
Phoenix SecureCore(tm) Setup Utility
Info System Advanced Security Boot Exit