18
- Locating the Controls and Connectors
Modem (RJ-11) Telephone Jack
The Modem (RJ-11) jack is for attaching a telephone line to the internal multinational 56K modem. (There
is no modem on systems with WWAN device.) See “Modem (RJ-11) Telephone Jack” on page 86.
Express Card Slot
TheE xpress Card Slot allows you to install an Express Card. See “Using Express/PC Cards” on page 79.
Flexible Bay
The flexible bay can accommodate any of the following modular devices. (See “Flexible Bay Devices”
on page 38.)
• Modular Dual-Layer Multi-Format DVD Writer
• Modular Lithium ion battery
• Weight Saver
USB 2.0 Ports
The USB 2.0 ports allow you to connect Universal Serial Bus devices. USB 2.0 transfers data at up to 480
Mbps and is backward-compatible with USB 1.1 devices, which transfer data at up to 12 Mbps. See
“Universal Serial Bus Ports” on page 88.
THE INTERNAL MODEM IS NOT INTENDED FOR USE WITH DIGITAL PBX SYSTEMS. DO NOT CONNECT THE
INTERNAL MODEM TO A DIGITAL PBX AS IT MAY CAUSE SERIOUS DAMAGE TO THE INTERNAL MODEM OR
YOUR ENTIRE TABLET PC. CONSULT YOUR PBX MANUFACTURER’S DOCUMENTATION FOR DETAILS.
S
OME HOTELS HAVE DIGITAL PBX SYSTEMS. BE SURE TO FIND OUT BEFORE YOU CONNECT YOUR
MODEM.
T
HE INTERNAL MULTINATIONAL MODEM IS DESIGNED TO THE ITU-T V.90/V.92 STANDARD. ITS MAXIMUM
SPEED OF 53000 BPS IS THE HIGHEST ALLOWED BY FCC, AND ITS ACTUAL CONNECTION RATE DEPENDS
ON THE LINE CONDITIONS. THE MAXIMUM SPEED IS 33600 BPS AT UPLOAD, IN ACCORDANCE WITH FCC
REGULATIONS.
F
OR ADDITIONAL INFORMATION ABOUT THE MODEM, REFER TO THE FUJITSU WEBSITE AT:
HTTP://SOLUTIONS.US.FUJITSU.COM/.
To Next Page
Loading...
