39
- Flexible Bay Devices
Cold-swapping
To cold-swap modular devices in your Flexible Bay follow these easy steps:
Your LifeBook will automatically detect the new device and activate it within your system. The drive
letters associated with the device will be created and listed under My Computer and Windows Explorer.
Hot-swapping
Hot-swapping is provided through the Safely Remove Hardware utility. The icon for the utility appears in
the system tray. Click on the icon and follow the on-screen instructions.
YOU SHOULD NEVER LEAVE YOUR FLEXIBLE BAY EMPTY WHEN THE NOTEBOOK IS IN OPERATION. IF
LEFT EMPTY, DUST OR FOREIGN MATTER MAY ACCUMULATE INSIDE THE NOTEBOOK.
1 Close any open files.
2 Shut down your LifeBook notebook.
3 Turn your system upside down.
4 As you press the Flexible Bay release
latch as shown in Figure
22, pull out the
Flexible Bay module until it is clear of
the bay. This will require light force.
5 Slide the device you are installing into
your notebook until it clicks into place.
6 It is now safe to turn your notebook
back on.
7 You can now access and use the
device.
Figure 22. Removing/installing a Flexible Bay device
Flexible Bay
Release Latch
Flexible Bay
(bottom view)
To Next Page
Loading...
