84
- Memory Upgrade Module
Checking the Memory Capacity
Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your notebook has recognized the change.
Windows 7: Check the memory capacity by clicking [Start] -> Settings -> Control Panel, then (while in
Category view) clicking the System and Security icon. Select the Security icon and check the amount of
memory next to “Installed memory (RAM):”.
Windows XP: Check the memory capacity by clicking [Start] -> Settings -> Control Panel, then double-
clicking the System icon. Select the General tab and check the amount of memory under “Computer:”
Removing a Memory Upgrade Module
1 Perform steps 1 through 4 of Installing a Memory Upgrade
Module.
2 Pull the clips sideways away from each side of the memory
upgrade module at the same time.
3 While holding the clips out, remove the module from the
slot by lifting it up and pulling it away from your notebook.
4 Store the memory upgrade module in a static guarded
sleeve.
5 Replace the cover and reinstall the screws.
Figure 34. Removing memory module
To Next Page
Loading...
