Working with the notebook
Connecting the mains adapter to the P ort Replicator
3
1
2
► Connect the power cable to the
mains adapter (1).
► Plug the power cable into the mains
socket (2).
► Connect the mains adapter cable to the DC
jack (DC IN) of the Port R eplicator (3).
When the noteboo k is connected to a Port Replicator, the operating system creates
a hardware pro file for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as the notebook is connected to a Port R eplicator of the same type.
Switching on the notebook via the port replicator
► Press the ON /OF F button on the port
replicator to switch the notebook on.
The po w er-on indicator of the P ort
Replicator lights up.
Switching off notebook via Port Replicator
► Close all applications and shut down your operating system (please refer
to the manual for the operating system).
If the notebook cannot be shut down properly, press the ON/OFF button
on the Port Replicator for approx. four seconds. The n otebook will switch
off. Any unsaved data ma y however be lost.
Fujitsu 51
To Next Page
Loading...
