Security functions
Installing Sys temLock
InstallingS yst emLock
During initial installation, the first SmartCard becomes the A dmin SmartCard. Together w ith the
PUK, it has all access rights, and should therefore be kept in a safe place. It must only be
used by an authorised user (Adm inistrator), for instance to initialise user cards.
You need an Admin SmartCard if you want to set up a u ser group. You use this
Admin SmartCard to add further systems to th e user group.
Setting up the fi rst system in a user group or a stand-alone
system for use with SystemLock
Usergroups
► Start th e device and call up BIOS Setup.
► From the Sec urity menu, choose the option SmartCard S ystemLock.
The following S martCa rd SystemLock m enu will be displayed:
Security
SmartCard SystemLock Item Specific Help
SmartCard SystemLock Not Installed
Install Single PC [Enter]
Install Group PC [Enter]
Installs the security
from a SystemLock Admin
SmartCard into this PC
without modifying any
data on the SmartCard.
A correct SmartCard is
required for a
permanent installation.
Enter PIN: [ ]
► Insert a new SmartCard in the reader and press En ter.
74 Fujitsu Technology Solutions
To Next Page
Loading...
