Security functions
► Now press the E nter key. The SystemLock administration menu will be displayed:
Security
SmartCard SystemLock Item Specific Help
SmartCard SystemLock Installed
Uninstall: [Enter]
BIOS Recovery: [Allowed]
SmartCard and Pin [Always required]
SmartCard Initialization
Admin SmartCard [Enter]
SuperUser SmartCard: [Enter]
User SmartCard: [Enter]
Service SmartCard: [Enter]
SmartCard Configuration
Change PIN: [Enter]
Change PUK: [Enter]
Unblock SmartCard: [Enter]
Allows to deactivate
The smartcard security.
ATTENTION:
Always check the BIOS
password settings after
uninstalling
SystemLock.
NOTICE:
Reinstalling a SinglePC
implies re-initializing
all of your smartcards
► For security reasons, the preset PUK should always be changed before removing
the new SmartCard. To do this, under SmartCard Config uratio n, select the option
Change PUK, press the Enter key and input the new PUK.
► First enter the preset PUK.
Enter the PUK:
New Sma rtCards have a preset PUK (see above).
You will need to know the PUK assigned to the SmartCard if you want to
re-initialise a previously initialised SmartCard.
► Enter the PUK.
When the following appears:
• ACCESS DENIED = You have entered an invalid PUK. After six failed attempts,
the SmartCard will be blocked and can no longer be used.
► Enter the new PUK as follows.
Enter new PUK:
Confirm new PUK:
A n umber with 4 to 8 digits is acceptable for the new PU K. For security
reasons, we recommend that you c hange the PU K for every SmartCard,
and use an 8-digit number each t ime.
► Re-en
ter the new PUK to confirm.
When the following appears:
• PIN/
PUK do not match = You have confirmed the P UK incorrectly. You will then
be re
quested to re-enter and reconfirm the new PUK.
F5,function keyF6,f unctionkeyF7,function keyF8, functionkeyF9,function keyF10,functionkey
Instructions on how to initialise an additional SmartCard ca n be found in Section "".
76 Fujitsu Technology Solutions
To Next Page
Loading...
