Removing and installing components
during servicing
Attaching the cover
1
1
2
► Place the cover in the correct mounting position (1).
► Fasten the screws (2).
► R eplace the dust chamber cover (see "
Removing and fit ting the dust removal
cove r (ventilati on slot cover)", Page 69).
Finishing component removal
After you have removed or changed the system components as you required, please
prepare your device for operation again as follows:
► In stall the battery again (se e "
Installing a battery", Page 62).
► Turn the notebook the right way up again and place it on a flat surface.
► R eco nnect the cables that you disconn ecte d before.
102 Fujitsu Technology Solutions
To Next Page
Loading...
