Fujitsu Lifebook T731 - Page 93

92 - Memory Upgrade Module
7 Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and
into the connector until it lodges under the retaining clip. You’ll hear a click when it is properly in place.
8 Replace the cover and reinstall the screws.
Figure 38. Opening Memory Compartment Figure 39. Installing a Second Memory Module
Retaining Clip
THE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR TABLET PC.
O
NCE IT IS INSTALLED, YOU CAN LEAVE IT IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM MEMORY
CAPACITY.
Claw T731 UG.book Page 92 Wednesday, May 25, 2011 3:50 PM