Working with the notebook
Calibrating the pen
Before using the pen for the first time, you should calibrate it so that the curso r follows the
movements of the pen as accurately as possible. You should also always repeat the calibration
if the c o-o rdination between the pen and cursor movement dete riorates.
Operating system Menu
Windows 7
To calibrate, call up the Hardware and Sound / Tablet PC Settings function
in the Control Panel. You need to calibrate both portrait and landscape
formats.
Replacing the pen tip
With use, the pen tip may become worn or may pick up foreign particles that can scratch the screen.
A da maged or w orn tip m ay not m ove freely, causing unpredictable results when using the pen.
If your p en exh ibits these problems, you should replace the pen tip. To do this, use the supplied tool (1).
1
► To remove the tip, position the tip in the gap
between the two ends of the tool supplied.
► Pinch the two en ds of
the supplied tool
together so that th
e tip is firmly clasped,
then pull it from t h
e barrel.
► To replace the tip, retrieve one of the
new tips that were supp lied your pen.
Insert the flat end of the tip into th e
barrel and exerting gentle pressure, push
it in until it is firmly in place.
If the tip is worn or damaged, discard it.
Installin g a pen co rd
You should attach the pen w ith a pen cord to prevent accidentally dropping or losing it.
► Attach the end of the pen cord with the smaller loop to your p en.
► Attach the end of the pen cord with the larger loop to your notebook.
Fujitsu 37
To Next Page
Loading...
