72
Problem Possible Cause Possible Solution
Audio Problem
There is no sound
coming from the
built-in speakers
Tablet PC does
not turn on
when installed
in optional Port
Replicator
You cannot access
your hard drive.
The Software volume
control is set too low.
Headphones are plugged
into your Tablet PC.
Software driver is not
confi gured correctly.
Sound could have been
muted with function keys.
Port Replicator AC adapter
is not plugged in.
Tablet PC is not properly
seated in the Port
Replicator.
The setup utility is
incorrectly set for your
internal (Primary Master)
or optional second hard
drive (Primary Slave).
The wrong drive designator
was used by an application
when a bootable CD-ROM
was used to start the Tablet
PC.
Security is set so your
operating system cannot
be started without a
password.
Adjust the sound volume control settings in your
software, operating system and applications.
Plugging in headphones disables the built-in
speakers, remove the headphones.
Refer to your application and operating system
documentation for help.
Press [F3] while holding the [Fn] key to toggle
the sound on and off.
Provide power to the Port Replicator.
Remove and re-dock your Tablet PC.
Revise BIOS settings to set both Primary Master
and Primary Slave correctly.
Verify drive designator used by application is in
use by the operating system. When the operating
system is booted from a CD, drive designations
are automatically adjusted.
Verify your password and security settings.
Port Replicator Problems
Hard Drive Problems
To Next Page
Loading...
