78
Problem Possible Cause Possible Solution
Shutdown and Startup Problems
The Suspend/Resume
button is disabled from the
Advanced submenu of the
Power menu of the setup
utility.
You did not hold the
button in long enough.
There may be a confl ict with
the application software.
The boot sequence settings
of the setup utility are
not compatible with your
confi guration.
You have a secured system
requiring a password to load
your operating system.
Power On Self Test (POST)
has detected a problem.
The system may be
password-protected.
BIOS setup changes were
not saved when you made
them and exited the BIOS
setup utility returning it to
previous settings.
The BIOS CMOS back-up
battery has failed.
Enable the button from the setup utility.
Hold the button longer. This may need to be a
few seconds if your application is preventing the
CPU from checking for button pushes.
Close all applications and try the button again.
Set the operatinag source by pressing the [ESC]
key while the Fujitsu logo is on screen or use the
[F2] key and enter the setup utility and adjust the
source settings from the Boot menu.
Make sure you have the right password. Enter
the setup utility and verify the Security settings
and modify them as accordingly.
See the Power On Self Test (POST) messages
to determine the meaning and severity of the
problem. Not all messages are errors; some are
simply status indicators.
Check the status indicator panel to verify that
the Security icon is blinking. If it is blinking, enter
your password.
Make sure you select Save Changes And Exit
when exiting the BIOS setup utility.
Contact your support representative for repairs.
This is not a user serviceable part but has a
normal life of 3 to 5 years.
The Suspend/
Resume button
does not work.
The system
powers up, and
displays power-on
information, but
fails to load the
operating system.
An error message
is displayed on
the screen during
the Tablet PC boot
sequence.
Your system display
won’t turn on when
the system is
turned on or when
the system has
resumed.
Your Tablet PC
appears to change
setup parameters
when you start it.
To Next Page
Loading...
