Security functions
► Enter the PUK.
When the following appears:
• ACCESS DENIED = You have entered an invalid PUK. A fter six failed attempts,
the SmartCard will be blocked and can no longer be used.
Please wait a few seconds after entering the PIN and PUK: SystemLo ck is being installed.
The following message will be displayed if installation is successful:
Setup Notice
Changes have been saved
[Continue]
Now press the Enter key. The SystemLock administration m enu will be displayed:
Security
SmartCard SystemLock Item Specific Help
SmartCard SystemLock Installed
Uninstall: [Enter]
BIOS Recovery: [Allowed]
SmartCard and Pin [Always required]
SmartCard Initialization
Admin SmartCard [Enter]
SuperUser SmartCard: [Enter]
User SmartCard: [Enter]
Service SmartCard: [Enter]
SmartCard Configuration
Change PIN: [Enter]
Change PUK: [Enter]
Unblock SmartCard: [Enter]
Allows to deactivate
The smartcard security.
ATTENTION:
Always check the BIOS
password settings after
uninstalling
SystemLock.
NOTICE:
Reinstalling a SinglePC
implies re-initializing
all of your smartcards
F5,function keyF6, functionkeyF8,function keyF9,f unc tionkey
Generate a user card for the device as described in Section "Carrying out
adm inistrator functions", Page 91.
► If you do not wan t to initialise any further SmartCards, press
Esc
and
remove th e Admin SmartCard.
90 Fujitsu Technology Solutions
To Next Page
Loading...
