Security functions
Switch o n the device using SystemL ock
If yo u have an internal SmartCard reader, you can sw itch on the device by inserting the SmartCard.
If you s witch on the device with t he On/Off switch then the following message appears:
Insert a SmartCard.
SystemLock
► Insert your SmartCard.
Enter PIN:
► Enter your PIN.
When the following appears:
ACCESS DENIED = You have entered an incorrect PIN. After three failed attempts, the
SmartCard will be blocked and can only be enabled again by entering the PUK.
Depending on the rights assigned to your SmartCard, you can select the following
functions when this message is displayed on the screen:
F2=Setup, F3=Change PIN
If your SmartCard has the appropria te rights, you can:
F2,function keyF3, functionkey
F2
: start BIOS Setup.
F3
: change PIN.
If you do not select a function, the system will boot up.
Start BIOS Setup
F2
A SmartCard with the appropriate rights must be inserted (SuperUser, Service or Admin).
Changing PIN
It is possible to change the PIN fo r any initialised SmartCard.
► Press the function key
F3
.
► Enter the old P IN.
► Enter t he new PIN.
A number with 4 to 8-digits is acceptable fo r the new PIN. For security
reasons, we recommend that you change the PIN for every SmartCard,
and use an 8-digit number each time.
► Confirm t
he new PIN.
Uninstall Sys temLock
► Start the device.
Uninstalling
► Follow the instructions given in sect ion "Carrying out administrator functions",
Pag e 91. Select "Uninstall" to uninstall SystemLock . You can now use the
device again without the need for a SmartCard.
94 Fujitsu Technology Solutions
To Next Page
Loading...
