Appendix
Determining whether Recovery and Utility is pre-loaded
1. Turn on or reboot your system. When the F ujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to t he Application Menu.
3. Check whether the Recovery and Utility option is present. If it is not present, it means
that the utility must be used from the Bootable Disk. Proceed to “Running Recovery and
Utility from the Bootable Disk” if Recovery and Utility is unavailable.
Running Recovery and Utility from hard disk
1. Turn on or reboot your system. When the F ujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to t he Application Menu.
3. Cursor down to Reco very and Utility and press the
Enter
key.
4. Choose your language, if necessary. Select Reco very and Utility to proceed.
5. Three tool options appear: Diagnostics, Recovery,andUtility (refer to the Recovery and
Utility tools section below for instructions on how to use these tools).
6. If this w as successful please skip the next step and g o to “Recovery and Utility tools.”
7. If this w a s NOT su ccessful, plea se go to the next step.
Running Recovery and Utility from the Bootable disk
To verify/ chan ge the boot-up priority (rat her than bo oting-up from the hard drive or
an external media drive), perform the following steps:
1. Power on your system. When the F ujitsu logo appears on the screen, press the
F12
key.
2. Insert the bootable disk into the drive tray.
3. Highlight t he CD/DVD option from the Boot menu, then press
Enter
.
4. Click OK.
5. Select CD/DVD boot mode: UEFI Mode, if applicable, and then press
Enter
.
While the files are being loade d fro m the disk, th e Fu jitsu logo screen will appe ar
followed by a progress bar at the bottom of the screen.
110 Fujitsu
To Next Page
Loading...
