Appendix
Recovery and Utility tools
Note: Reco very and Utility tools may n ot be available on your system depending
on the region f rom which the system was shipped.
Diagnostics tool: Th e Diagnostics tool is designed for use by IT professionals. It is not likely you
will need to use this tool. If you should need to use this tool, perform the following steps:
1. Press the Diagnostics Tool bu tton to start the Diagnostics tool.
2. Read the n ote, and then click OK.
3. Choose one or more of the following options for diagno stics on the Fujitsu Hard ware Diagnostics
Tool window: CPU, Memory, Display, Hard Disk, CD /DVD/BD, Floppy Disk, Keyboard, and Mouse.
4. Click the Option butt on in the Tool menu to specify how many times the tool
should run diagnostics on each selected component.
5. Press Execute to start the Diagnostics tool.
6. After the execution is completed, the selected components are circled in red to indicate that they
have been diagnosed and the result dialog window opens. Click Close to close the w ind ow.
7. Click End to close the Diagnostics tool, and then click Yes to confirm the end of diagnostics session.
Recovery tool: The Recovery tool contains two options:
• Restore C Drive: Restore reco v e ry image (only C: drive)
• Restore Full Hard Drive: Restore recovery image (full ha rd drive).
You can use these too ls to restore the Recovery Image from th e h idden p artition, and perform a full
hard drive re covery. Please refer to instructions above for details on how to c reate a Recove ry Image.
Restore the Re
covery Image from Hidden Partition
1. Click [Restore C: drive] from Recovery and Utility tools
2. The progress
bar is followed by “Restore Reco v ery image (only C: drive)” screen
confirming t
hat the Image will be restored to the C: drive. Click Next.
3. Read the instruction screen and select Agree,thenclickNext.
4. Click OK to
acknowledge the warning message to restore recovery image to the C: drive.
5. W hen the progress bar appears, wait for the p rocess to complete.
6. Click Fin
ish w hen the process completes; the computer will restart to Windows.
7. Follow the steps listed in the “Auto Installation sup port for software packages
from hidden partition” section.
8. Downloa
d FSDM (Fujitsu Software Download Mana ger) from the sup port site and download
all the
software applicable to the model and O S using FSDM.
9. Follow the steps listed in “Auto Installation support for software packages
downloaded from support website” section.
Fujitsu 111
To Next Page
Loading...
