EasyManua.ls Logo

Fujitsu LIFEBOOK U748 - Removing and Installing Components - M.2 Module Procedures; M.2 Module Installation and Removal

Fujitsu LIFEBOOK U748
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Removing and installing components
during servicing
Installing and removing an M.2 m
odule
LIFEBOOK U728 and LIFEBOOK U748 each have a service compartment for an M.2
module. In LIFEBOOK U758, you can either install an M.2 module (with a corresponding
M.2 adapter) or a standard hard disk (HDD, without M.2 adapter). To do so, see
"
Removing
and installing hard disks (HDD, LIFEBOOK U758 only)", Page 75.
Removing a cover
1
1
2
Remove the scr
ews (1).
Keep the scre
ws in a safe place. If you are removing more than one component at
thesametime
, store the screws for the individual components separately from each
other. If you
install the wrong screws, components may be damaged.
The screws a
re not all the same length and when the cover is installed,
the correc
t screws must be used.
Lift the cover off the notebook (2).
72 Fujitsu

Table of Contents

Related product manuals