Troubleshooting and tips
Using the battery switch-off button
If the d evice stops resp onding and no longer reacts to the On/O ff s witch, u se the
battery switch-off button to shut down the device.
► D isconnect the device from the mains adapter.
► Push a pen or a piece of wire (such as a paper clip) firmly into the opening of
the battery switch-off button to shut down the system.
► C onnect the mains adapter to the device again.
► Switch the d evice on again.
Restoring the hard disk contents under Windows
Harddisk:Operatingsystem,restoring
To perform the following steps, you must connect an external optical
drive (available as an option) to the device.
You can use t he "Windows Recovery CD" (optionally available) and the "Drivers & Utilities
CD/DVD" to reinstall the operating system.
The instructions are provided on the case of the Recovery CD.
During the reinstall process your personal files and any installed programs
will be de lete d. We advise you to backup your files to an external hard
drive, or CD / DVD disk before you start.
► Switch the notebook on.
The followin
g display briefly appears on the screen during start-up:
<ESC>Diagnostic screen <F12>Boot Menu <F2>BIOS Setup
► When this message appears, press the function key
F12
.
► In sert th e
"Windows Recovery CD" into the optica l drive.
► Select CD-ROM and press the Enter key.
► Follow th
e instructions on the screen.
After the installation you must install all the drivers again. Some installed hardware
components will not be correctly supported until this has been done.
► Insert the "Drive rs & Utilities" CD/DVD into the optical drive. The CD starts automatically.
► Click o
ntheDesk Update button.
► Select Automatic driver installation (Express) and click on Start installation.
► Follo
w the instructions on the screen.
► R esta rt your notebook when the driver installation is completed.
50 Fujitsu Tech nology Solutions
To Next Page
Loading...
