Fujitsu M10 - Page 146

Table 3-17
Problems resolved in XCP 2070 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
130903-006
xIf multiple physical partitions (PPARs)
exist in a system consisting of multiple
SPARC M10-4S units, and some SPARC
M10-4S units are turned off and then on
again, an "SRAM Serious Error" may
occur, requiring the replacement of the
CPU memory unit lower (CMUL). When
the state is displayed with the
showpparstatus(8)
command or the
showdomainstatus(8) command, the
PPAR state may not be displayed
correctly.
There is no effective workaround.
While a PPAR is operating, do not turn
off the SPARC M10-4S. Use the
poweroff(8) command, for example, to
stop a PPAR before turning it off.
RTIF2-
130903-007
xx xIf the setcod(8) command is executed
repeatedly on the physical partition
(PPAR) in the PowerOn state, the
resources available within the process
may be exhausted, and codd may cause a
process down.
You can avoid this by executing setcod(8)
when PPAR is in the PowerOff state.
[How to restore]
Restart codd.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015132