Fujitsu M10 - Page 149

Table 3-17
Problems resolved in XCP 2070 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
131004-002
xIf, in a system configured with 3 BB or
greater, the chassis of the master XSCF
and the standby XSCF are turned off and
then on again, the system enters a state in
which there is no master XSCF. If the
master XSCF is stopped while the XSCF
DUAL control cable
is either faulty or not
connected, master/standby XSCF
switching is suppressed, so that the
standby XSCF is not switched to the
master XSCF.
There is no effective workaround.
Update to firmware version XCP 2070 or
later.
RTIF2-
131004-003
xIf master/standby XSCF switching occurs
while the XSCF DUAL control cable is
either faulty or not connected, switching
may be performed even though
communication between the master and
standby is not guaranteed.
If an XSCF is configured and master/
standby XSCF switching is performed
while the XSCF DUAL control cable is
either
faulty or not connected, the
information set in the XSCF will be erased.
There is no effective workaround.
Perform master/standby XSCF switching
while the XSCF DUAL control cable is
connected normally.
Whether the XSCF DUAL control cable is
connected normally can be confirmed
with the following procedure.
1. Execute the showsscp -a command.
2. Check that, in the output results
obtained in Step 1., "Cannot
communicate."
is not displayed for the
Address for which the SSCP link
network ID (network_id) is 2 or 4.
[Example]
If there is no crossbar box, confirm the
Address with an SSCP link network ID
(network_id) of 2.
XSCF>
showsscp -a -N 2
:
:
Location Address
------------- ---------------
bb#00-if#2 169.254.1.17
bb#01-if#2 169.254.1.18
Similarly, if
there is a crossbar box,
confirm the Address with an SSCP link
network ID (network_id) of 4.
Chapter 3 Information on Software 135