CHAPTER 3CHAPTER 3
CHAPTER 3CHAPTER 3
CHAPTER 3
AWARDAWARD
AWARDAWARD
AWARD
®
BIOS SETUP BIOS SETUP
BIOS SETUP BIOS SETUP
BIOS SETUP
3-23
Wake-Up on LAN
To use this function, you need a LAN add-on card which support power on
functions. It should also support the wake-up on LAN jumper (JWOL1).
Enabled Wake up on LAN supported.
Disabled Wake up on LAN not supported.
CPU Thermal-Throttling
Select the CPU THRM-Throttling rate. The settings are: 25.0%, 37.5%, 50.0%,
62.5%, 75.0%, 87.5%.
Resume by Alarm
This function is for setting date and time for your computer to boot
up. During Disabled, you cannot use this function. During Enabled, choose
the Date and Time Alarm:
Date(of month) Alarm You can choose which month the
system will boot up. Set to 0, to boot
every day.
Time(hh:mm:ss) Alarm You can choose what hour, minute and
second the system will boot up.
Note: If you have change the setting, you must let the system boot up
until it goes to the operating system, before this function will work.
Reload Global Timer EventsReload Global Timer Events
Reload Global Timer EventsReload Global Timer Events
Reload Global Timer Events
Reload Global Timer events are I/O events whose occurrence can prevent the
system from entering a power saving mode or can awaken the system from
such a mode. In effect, the system remains alert for anything which occurs to
a device which is configured as Enabled , even when the system is in a power
down mode.
Primary IDE 0
Primary IDE 1
Secondary IDE 0
Secondary IDE 1
FDD, COM, LPT Port
PCI PIRQ[A-D] #
To Next Page
Loading...
