5. Removing the PDP Unit (2 of 2)
* View after the Front Case Panel Unit and
PCBs were removed.
7. Remove the Main Power PCB.
8. Remove the 2 circled screws and sensor PCB.
9. Remove the 11 circled screws and Base Frame
together with Fans.
10. Remove the 6 circled screws and shield plate.
11. Disconnect the 1 circled connector.
6. Remove the Base Frame from the Front
Case together with the panel and PCBs.
- 35 -
* View after only the PDP Unit was removed.
* Replace the removed parts back in the correct
places when the PDP Unit is replaced.
To Next Page
Loading...
