9.2 Names and Functions of Parts
9.2.2 Rear side
The names and functions of parts on the rear of the Expansion Disk Cabinet are as follows.
(4) AC main line switch
Empty Bay for
a Redundant
Power Supply
(option)
(3) AC power input
(2) RCI connector
SCSI IN (Base)
SCSI IN (Expansion)
SCSI OUT (Base)
SCSI OUT (Expansion)
(1) SCSI connectors
Figure 9.2 Rear of Expansion Disk Cabinet
(1) SCSI connectors
The Expansion Disk Cabinet is equipped with two built-in SCSI connectors, one for the base SCSI
bus and the other for the expansion SCSI bus.
In the base configuration, connect the SCSI cable only to the SCSI IN (base) connector and connect
the terminator plug to the SCSI OUT (base) connector.
If the Disk Expansion Unit is installed, connect the SCSI cable to the SCSI IN (expansion)
connector and connect the terminator plug to the SCSI OUT (expansion) connector.
169
To Next Page
Loading...
