Fujitsu Primepower200 - Hot-swapping Redundant Components

9.5 Hot-swapping Redundant Components
9.5 Hot-swapping Redundant Components
This section describes hot-swapping of redundant components.
9.5.1 Power supply units
CAUTION
Unit Damage
The unit may be damaged if hot-swapping of power supply units is not
performed correctly. Contact the service engineer if a power supply unit must be
hot-swapped.
IMPORTANT
Adding an optional redundant power supply unit allows hot-swapping of the power supply units.
Power supply units installed on the Expansion Disk Cabinet are hot-swappable. To enable hot-swapping, use the
tools (machine administration) contained in the "Enhanced Support Facility" to perform hot-swapping. For details
on how to swap power supply units, refer to the "Machine Administration Instructions" included with the
"Enhanced Support Facility".
175