Fujitsu Primepower200 - Hard Disk Drives

CHAPTER 11 Internal I/O Units
11.1 Hard Disk Drives
This section describes the following items:
 SCSI ID
 Handling precautions
 Formatting hard disk drives
 Backup up data
 Hot-swapping hard disk drives
11.1.1 SCSI ID
The SCSI ID of hard disk drives is automatically determined by where the disk is mounted in the disk drive
configuration.
11.1.2 Handling precautions
CAUTION
Unit Damage
Pay attention to the following points when handling the hard disk drive. If these
precautions are not observed the hard disk drive may be damaged or data lost.
 Do not subject the unit to excessive impact.
 Do not bring the unit near to equipment (motors, speakers, etc.) that
generate strong magnetic fields.
 Do not store the unit in locations likely to cause condensation inside the unit
or in locations subject to sudden changes in temperature or humidity.
11.1.3 Formatting hard disk drives
IMPORTANT
When a disk is formatted, any data on the disk is lost. Take care when selecting which the drive to
format.
Back up data as necessary before formatting a disk drive.
The disk drives are pre-formatted at factory, so initial formatting by the user is not required.
If a new hard disk drive must be formatted later, use the Solaris format utility to format the disk. Select "Auto
configure" when using the format utility to format a disk drive.
186