Fujitsu Primepower200 - Inserting a CD-ROM Disc; Ejecting a CD-Rom Disc

CHAPTER 11 Internal I/O Units
11.2.4 Inserting a CD-ROM disc
1
With the PRIMEPOWER’s POWER LED lit, check that the BUSY LED on the front panel of the CD-ROM
drive is out.
2 Press the Eject button. The tray of the CD-ROM drive comes out.
3 Place the CD-ROM disc on the tray.
4 Repress the Eject button.
The tray goes in, and the CD-ROM disc is mounted in the drive.
11.2.5 Ejecting a CD-ROM disc
1
If the system is running, check that the disk is not in use by a user or a program. If the CD-ROM disc is in use,
the user process should be stopped to enable ejection of the CD-ROM disc.
2 Execute the Solaris eject command, or use the "Eject disk" function in the Volume Manager. The tray comes
out.
3 Remove the CD-ROM disc, then repress the Eject button.
The tray goes in.
190