BX900 S1 Operating Manual 121
Hot-plug components
Figure 43: Removing a dummy connection blade module
Ê Press the handles of the dummy module inward and pull it out of the slot.
Installation is carried out in the reverse order.
I Keep the dummy modules for future use. If you remove a
connection blade and do not replace it with a new one, you must install a
dummy module in the empty slot.
Installing a single-width connection blade
V CAUTION!
Make sure you observe the safety notes and the information on handling
electrostatic-sensitive devices in the section "Modules with Electrostatic-
Sensitive Devices" on page 34.
Ê Unpack the connection blade.
To Next Page
Loading...
