© 2011 Fujitsu Technology Solutions
Severity Level 6
Error Message Unit: <unit-id>: Can't send ekeying status
Explanation eKeying status can’t be sent from stack member to stack master.
Recommended Action Checking the stacking cable if it is connected probably or not.
Severity Level 6
Error Message Unit <unit-id> attached successfully
Explanation Unit is attached successfully in the stack.
Recommended Action Unit is ready for operation.
Severity Level 6
Error Message Error: usp <unit>/<slot>/<port>: Card Not Attached,
cmd=<cmd>, count=<count>, task: <taskname>
Explanation Interface unit/slot/port is not presented so that the command
<cmd> can’t be applied to the chipset.
Recommended Action Just a notice. After the interface is attached, the configuration
will be applied to the chipset automatically.
Severity Level 6
Error Message Stack Port Link Up: Index: 100 Unit: 1 Tag: Stack 1
Explanation The stack port (Stack 1) of unit ID 1 is link up.
Recommended Action The stack port is link up. You could check if the new unit is joined
to the stack.
Severity Level 6
Error Message Stack Port Link Up: Index: 101 Unit: 1 Tag: Stack 2
Explanation The external stack port (Stack 2) of unit 1 is link up.
Recommended Action The external stacking port is link up on unit 1.
Severity Level 6
Error Message Stack Port Link Down: Index: 100 Unit: 1 Tag: Stack 1
Explanation The stack port (Stack 1) of unit ID 1 is link down.
Recommended Action User should check if the internal stacking link is disabled from
MMB.
Severity Level 6
Error Message Stack Port Link Down: Index: 101 Unit: 1 Tag: Stack 2
Explanation The external stack port (Stack 2) of unit 1 is link down.
Recommended Action User should check if the external stacking cable is removed.
Please reconnect the stacking cable if you want to maintain the
original stack.
To Next Page
Loading...
