© 2011 Fujitsu Technology Solutions
Severity Level 5
Error Message Management unit conflict was detected and this unit has lost the
manager election. All the units in this stack will reset and join the
winner Stack Manager %x:%x:%x:%x:%x:%x.
Explanation Two stack masters in a stack, the current stack master loses the
master role and all the units belonging to this stack will be reset
and join the winner stack master later.
Recommended Action Please refer to the power consideration sequences of a stack to
prevent two stack masters in the same stack at the same time.
Severity Level 0
Error Message Auto upgrade reset unit <unit-id>
Explanation The FW of this unit is auto-upgrade complete by the stack
master and stack master reset this unit.
Recommended Action A notification message for user that this unit is reset by the stack
master due to the auto image upgrade complete.
Severity Level 5
Error Message No Potential unit to configure as Standby when unit <unit-id>
joined
Explanation No other unit to be configured as the standby unit. This unit
should be the only one stack member in the stack.
Recommended Action No standby unit is used in current stack.
Severity Level 5
Error Message No Potential unit to configure as Standby when unit <unit-id> left
Explanation No other unit to be configured as the standby unit. This unit
should be the only one stack member in the stack.
Recommended Action No standby unit is used in current stack.
Severity Level 5
Error Message Admin configured standby %d left the stack
Explanation The configured standby unit is left the stack.
Recommended Action Checking if this unit has been removed from the stack.
Severity Level 3
Error Message This unit <unit-id> does not have admin management preference
enabled
Explanation This unit has been configured to be a non-management unit. It
can’t be selected as a standby unit.
Recommended Action To enable the admin management preference if you want this
unit to be a standby unit.
To Next Page
Loading...
