© 2011 Fujitsu Technology Solutions
Error Message Could not set the simple policing committed rate value.
Explanation User try to configure the simple policing committed rate, but the
Class name is not associated with the policy.
Recommended Action Refresh the WEB page, and select the Class name again.
Error Message If Conform Action Selector or Violate Action field selected Mark
Cos, the other field should be Drop.
Explanation User try to add a Police Simple Attribute to a DiffServ Policy, and
select the Conform or Violate action with ‘Mark CoS’ , but the
other action does not set to ‘Drop’.
Recommended Action Set Conform or Violate action with ‘Mark CoS’ for a DiffServ
Policy Attribute, the other action must set to ‘Drop’.
Error Message Could not set the policy attribute type.
Explanation User try to configure the policy attribute type, but the Class name
is not associated with the policy.
Recommended Action Refresh the WEB page, and select the Class name again.
Error Message Could not set the mirror interface.
Explanation User try to configure the mirror interface of the policy attribute,
but the Class name is not associated with the policy.
Recommended Action Refresh the WEB page, and select the Class name again.
Error Message Could not set the redirect interface.
Explanation User try to configure the redirect interface of the policy attribute,
but the Class name is not associated with the policy.
Recommended Action Refresh the WEB page, and select the Class name again.
Error Message Color Aware mode requires the existence of one or more color
classes that are valid for use with this policy instance. Press
'Help' for more details.
Explanation User try to configure the Color Aware attribute of a DiffServ
Policy Attribute, but the system can not apply the setting.
Recommended Action 1. Create 2 DiffServ Classes(C1 and C2), and one Class(C2)
must contains a single, non-excluded match criterion for one of
the following fields ‘CoS’ , ‘IP DSCP’ , ‘IP Precedence’.
2. Create a DiffServ Policy(P1) and add 2 DiffServ Classes to the
Member Class List.
3. In the ‘Class Definition’ tab, add a ‘Police Simple’ Attribute
with C1 class for P1 policy. Click the ‘Configure Selected
Attribute’ button.
4. Change the Color Mode to ‘Color Aware’, and confirm the
setting, the Color Aware Mode should be applied successfully.
To Next Page
Loading...
