Fujitsu PRIMERGY BX900 - Page 56

© 2011 Fujitsu Technology Solutions
Severity Level 6
Error Message Unable to initialize dot1xTimerTask()
Explanation Unable to initialize dot1x timer task when initialize dot1x tasks
and data.
Recommended Action The dox1 mdoule is failed to init
Severity Level 6
Error Message dot1xCtlAdminModeDisable: could not set state to authorized,
intf <Interface Number>
Explanation Could not set state to authorized when disable administrative
mode setting for dot1x.
Recommended Action Cannot set the dot1x under the interface number, check the
interface number is available not.
Severity Level 6
Error Message Failure in applying config data for interface <Interface Number>
Explanation Failure in applying config data for interface.
Recommended Action The interface number is not available for the dot1x module.
Severity Level 6
Error Message dot1xIntfChangeCallback: Received an interface change
callback while not ready to receive it
Explanation Received an interface change callback while not ready to
receive it.
Recommended Action The interface number is not available for the dot1x module
Severity Level 6
Error Message dot1xIhProcessIntfChange L7_DOWN: failed sending terminate
cause, intf <Interface Number>
Explanation Failed sending terminate cause when port down.
Recommended Action Port down trap occurred.
Severity Level 6
Error Message dot1xIhProcessIntfChange L7_DISABLE: failed sending
terminate cause, intf <Interface Number>
Explanation Failed sending terminate cause when port disabled.
Recommended Action Port disable trap event