Brocade 5450 Hardware Reference Manual 19
53-1001266-02
Setting the Embedded Switch Module IP address
3
c. From the Hyperterminal window, select an available COM port from the Connect using list
and click OK.
The Port Settings dialog box displays.
FIGURE 5 COM Properties dialog box
d. From the COM Properties window, select the following configuration values and click OK.
• Bits per second: 115200
• Databits: 8
• Parity: None
• Stop bits: 1
• Flow Control: None
The Hyperterminal is connected and ready to accept text.
FIGURE 6 Hyperterminal
e. Use the MMB default username and password. The default is admin for the username
and admin for the password.
The Embedded Switch Module comes direct from the factory with an additional startup
process to set the initial password. If you want to bypass setting the initial password, use
Control-C to exit or press Enter to proceed. The password will not be changed. You will be
prompted again at the next login until the password is changed.
To Next Page
Loading...
