© 2011 Fujitsu Technology Solutions
104
Configurable Data
Password Minimum Length - You can use this screen to set minimum password length and this
configured only support user account setting.
User Name - Enter the name you want to give to the new account. (You can only enter data in this
field when you are creating a new account.) User names are up to eight characters in length and are
not case sensitive. Valid characters include all the alphanumeric characters as well as the dash ('-')
and underscore ('_') characters.User name "default" is not valid.
Password - Enter the optional new or changed password for the account. It will not display as it is
typed, only asterisks(*) will show. Passwords are up to eight alpha numeric characters in length, and
are case sensitive.
Confirm Password - Enter the password again, to confirm that you entered it correctly. This field will
not display, but will show asterisks (*)
Privilege Level – Enter a privlelge level for the accont. It will define the access right for the account
and only the highest value 15 has read/write access right.
Encryption Key - If you selected DES in the Encryption Protocol field enter the SNMPv3 Encryption
Key here. Otherwise this field is ignored. Valid keys are 8 to 64 characters long. The Apply checkbox
must be checked in order to change the Encryption Protocol and Encryption Key.
Non-Configurable Data
Access Mode - Indicates the user's access mode. The admin account always has 'Read/Write'
access, and all other accounts have 'Read Only' access.
SNMP v3 Access Mode - Indicates the SNMPv3 access privileges for the user account. The admin
account always has 'Read/Write' access, and all other accounts have 'Read Only' access.
Command Buttons
Apply - Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Delete - Delete the currently selected user account. If you want the switch to retain the new values
across a power cycle, you must perform a save. This button is only visible when you have selected a
user account with 'Read Only' access. You cannot delete the 'Read/Write' user.
To Next Page
Loading...
