© 2011 Fujitsu Technology Solutions
113
9.2.6.4 Configuring Hosts
This allows to configure to send the logged messages to a host.
Figure : Logging Hosts Config
Selection Criteria
Host - This is a list of the hosts that have been configured for syslog. Select a host for changing the
configuration or choose to add a new hosts from the drop down list.
Severity Filter -A log records messages equal to or above a configured severity threshold. Select
the severity option by selecting the corresponding line on the pull down entry field. These severity
levels have been enumerated below:
• Emergency (0): system is unusable
• Alert (1): action must be taken immediately
• Critical (2): critical conditions
• Error (3): error conditions
• Warning (4): warning conditions
• Notice(5): normal but significant conditions
• Informational(6): informational messages
• Debug(7): debug-level messages
Configurable Data
IPv4 Address - This is the IPv4 address of the host configured for syslog.
Host Name - This is the IPv4 Host Name of the host configured for syslog.
Host Name V6 - This is the IPv6 Host Name of the host configured for syslog.
IPv6 Address - This is the IPv6 address of the host configured for syslog.
Port -This is the port on the host to which syslog messages are sent. The default port is 514. Specify
the port in the text field.
Non Configurable Data
Status -This specifies wether the host has been configured to be actively logging or not.
To Next Page
Loading...
