Fujitsu PRIMERGY BX900 - Page 216

© 2011 Fujitsu Technology Solutions
214
9.3.9.3 VLAN Config
Figure : IGMP Snooping VLAN Config
Selection Criteria
VLAN ID - Specifies list of VLAN IDs for which IGMP Snooping is enabled.
Fast Leave Admin Mode - Enable or disable the IGMP Snooping Fast Leave Mode for the specified
VLAN ID.
Configurable Data
VLAN ID - Appears when "New Entry" is selected in VLAN ID combo box. Specifies VLAN ID for
which pre-configurable Snooping parameters are to be set.
Admin Mode - Enable or disable the IGMP Snooping for the specified VLAN ID.
Group Membership Interval - Sets the value for group membership interval of IGMP Snooping for
the specified VLAN ID. Valid range is (Maximum Response Time + 1) to 3600.
Maximum Response Time - Sets the value for maximum response time of IGMP Snooping for the
specified VLAN ID. Valid range is between 1 to 25.Its value should be less than group membership
interval value.
Multicast Router Expiry Time - Sets the value for multicast router expiry time of IGMP Snooping for
the specified VLAN ID. Valid range is 0 to 3600.
Command Buttons
Apply - Update the switch with the values you entered.
Disable - Update the switch with the default values.