Fujitsu PRIMERGY BX900 - Page 292

© 2011 Fujitsu Technology Solutions
290
9.4.3.2 Server Config
Figure : RADIUS Server Config
Selection Criteria
RADIUS Server - Selects the RADIUS server to be configured. Select add to add a server in type of
IPv4/IPv6 Address or Host Name.
Primary Server - Sets the selected server to the Primary or Secondary server.
Message Authenticator - Enable or disable the message authenticator attribute for the selected
server.
Configurable Data
IPv4 Address - - The IPv4 address of the server being added.
You cannot define these IPv4 addresses:
− 0.0.0.0
− 255.255.255.255
− 224.xxx.xxx.xxx
− 127.0.0.1
IPv6 Address - - The IPv6 address of the server being added.
You cannot define these IPv6 addresses:
− 0::0 (Unspecified)
− 0::1 (Loopback)
− Multicast
Host Name -The host name of the server being added.
Port - The UDP port used by this server. The valid range is 0 - 65535.
Secret - The shared secret for this server. This is an input field only.
Apply - The Secret will only be applied if this box is checked. If the box is not checked, anything
entered in the Secret field will have no affect and will not be retained. This field is only displayed if
the user has READWRITE access.
Encrypted - When the secret string is encrypted, this box need to be checked. This field is only
displayed if the user has READWRITE access.
Non-Configurable Data