© 2011 Fujitsu Technology Solutions
441
10.4.6.2.8 set igmp
This command enables IGMP snooping on a particular VLAN, and in turn enabling IGMP snooping on all
interfaces participating in this VLAN.
Syntax
set igmp <1-4093>
no set igmp <1-4093>
<1-4094> - VLAN ID (Range: 1 - 4093).
no - This command disables IGMP snooping on a particular VLAN, and in turn disabling IGMP
snooping on all interfaces participating in this VLAN.
Default Setting
None
Command Mode
Vlan database
10.4.6.2.9 set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval on a particular VLAN. The Group Membership
Interval time is the amount of time in seconds that a switch will wait for a report from a particular group
on a particular interface, which is participating in the VLAN, before deleting the interface from the entry.
This value must be greater than IGMP Maximum Response time value. The range is 2 to 3600 seconds.
Syntax
set igmp groupmembership-interval <1-4093> <2-3600>
no set igmp groupmembershipinterval <1-4093>
<1-4093> - VLAN ID (Range: 1 - 4093).
<2-3600> - The range of group membership interval time is 2 to 3600 seconds.
no - This command sets the IGMP Group Membership Interval time on a particular VLAN to the
default value.
Default Setting
260
Command Mode
Vlan database
To Next Page
Loading...
