© 2011 Fujitsu Technology Solutions
442
10.4.6.2.10 set igmp maxresponse
This command sets the IGMP Maximum Response time on a particular VLAN. The Maximum Response
time is the amount of time in seconds that a switch will wait after sending a query on an interface, which
is participating in the VLAN, because it did not receive a report for a particular group in that interface.
This value must be less than the IGMP Query Interval time value.
Syntax
set igmp maxresponse <1-4093> <1-25>
no set igmp maxresponse <1-4093>
<1-4094> - VLAN ID (Range: 1 - 4093).
no - This command sets the IGMP maximum response time on a particular VLAN to the default
value.
Default Setting
10
Command Mode
Vlan database
10.4.6.2.11 set igmp mcrtexpiretime
This command sets the Multicast Router Present Expiration time on a particular VLAN. This is the
amount of time in seconds that a switch will wait for a query to be received on an interface, which is
participating in the VLAN, before the interface is removed from the list of interfaces with multicast routers
attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-out, i.e. no expiration.
Syntax
set igmp mcrtexpiretime <1-4093> <0-3600>
no set igmp mcrtexpiretime <1-4093>
<1-4093> - VLAN ID (Range: 1 - 4093).
<0-3600> - The range of the Multicast Router Present Expire time is 0 to 3600 seconds.
no - This command sets the IGMP Multicast Router Present Expire time on a particular VLAN to the
default value.
Default Setting
10
Command Mode
Vlan database
To Next Page
Loading...
