Fujitsu PRIMERGY BX900 - Page 479

© 2011 Fujitsu Technology Solutions
477
This command enables Link Aggregation Control Protocol (LACP) on all ports.
Syntax
lacp all
no lacp all
all - All interfaces.
no - This command disables Link Aggregation Control Protocol (LACP) on all ports.
Default Setting
Enabled
Command Mode
Global Config
10.4.10.11 channel-group
This command adds one port to the port-channel (LAG). The first interface is a logical slot and port
number of a configured port-channel.
Note: Before adding a port to a port-channel, set the physical mode of the port. See ‘speed-duplex’
command.
Syntax
channel-group <slot/port>
<slot/port> - Port-Channel Interface number.
Default Setting
None
Command Mode
Interface Config
Command Usage
The maximum number of members for each Port-Channel is 8.