Fujitsu PRIMERGY BX900 - Page 487

© 2011 Fujitsu Technology Solutions
485
10.4.11.6 switchport multicast {bps|pps} <1-4294967295> [k|m|g]
This command will protect your network from multicast storms by setting a threshold rate for multicast
traffic on each port.
Syntax
switchport multicast {bps|pps} <1-4294967295> [k|m|g]
no switchport multicast
bps: bit per second, specify the rising threshold bit rate for multicast storm.
pps: packet per second, specify the rising threshold packet rate for multicast storm.
<1-4294967295>: threshold rate range is from 1 to 4294967295.
[k|m|g]: rate unit, k means threshold rate would be multiply 1000, m means threshold rate would be
multiply 1000000, g means threshold rate would be multiply 1000000000.
no - This command set the threshold rate to default.
Default Setting
512 pps
Command Mode
Interface Config
This command will protect your network from multicast storms by setting a threshold rate for multicast
traffic on all ports.
Syntax
switchport multicast all {bps|pps} <1-4294967295> [k|m|g]
no switchport multicast all
bps: bit per second, specify the rising threshold bit rate for multicast storm.
pps: packet per second, specify the rising threshold packet rate for multicast storm.
<1-4294967295>: threshold rate range is from 1 to 4294967295.
[k|m|g]: rate unit, k means threshold rate would be multiply 1000, m means threshold rate would be
multiply 1000000, g means threshold rate would be multiply 1000000000.
all - This command represents all interfaces.
no - This command set the threshold rate to default.
Default Setting
512 pps
Command Mode
Global Config