© 2011 Fujitsu Technology Solutions
515
10.6.3.4 server enable
This command is used to enable or disable telnet server.
Syntax
server enable
no server enable
no - This command sets to disable.
Default Setting
Disabled
Command Mode
Line Vty
10.6.3.5 exec-timeout
This command sets the remote connection session timeout value, in minutes. A session is active as long
as the session has been idle for the value set. A value of 0 indicates that a session remains active
indefinitely. The time is a decimal value from 0 to 160.
Syntax
exec-timeout <1-160>
no exec-timeout
<sec> - max connect time (Range: 1 -160).
no - This command sets the remote connection session timeout value, in minutes, to the default.
i
Changing the timeout value for active sessions does not become effective until the session
is reaccessed. Any keystroke will also activate the new timeout duration.
Default Setting
5
Command Mode
Line Vty
To Next Page
Loading...
