Fujitsu PRIMERGY BX900 - Page 519

© 2011 Fujitsu Technology Solutions
517
10.6.3.8 sessions
This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be
established until there are no more sessions available. If sessions are disabled, no new telnet sessions
are established. An established session remains active until the session is ended or an abnormal
network error ends it.
Syntax
sessions
no sessions
no - This command disables telnet sessions. If sessions are disabled, no new telnet sessions are
established.
Default Setting
Enabled
Command Mode
Line Vty
10.6.3.9 terminal-length
This command is used to sets the terminal-length of the cli vty terminal.
Syntax
terminal-length <10-100>
no terminal-length
<length> - max threshold (Range: 10 - 100).
no - This command sets the length to the default.
Default Setting
24
Command Mode
Line Vty