Fujitsu PRIMERGY BX900 - Page 570

© 2011 Fujitsu Technology Solutions
568
10.6.14.4 enable ipv6 stack for oob
This command is used to enable the IPv6 stack for out-of-band mgmt interface.
Syntax
oob ipv6 enable
no oob ipv6 enable
no – Disable IPv6 stack.
Default Setting
Enabled
Command Mode
Global Config
10.6.14.5 enable ipv6 stack for switchport
This command is used to enable the IPv6 stack for in-band mgmt interface.
Syntax
ipv6 enable
no ipv6 enable
no – Disable IPv6 stack.
Default Setting
Disabled
Command Mode
Interface-Vlan Config